Wireless Amperage Control for Welding Units

The WAC Wireless Remote Control lets you vary your welding unit’s amperage up to 2000 feet.

It installs in minutes. You can change your amperage by just turning a dial without pressing any buttons. Plus, you get immediate acknowledgement of your change.

The unit has been field tested for over eight years, in temperatures of below – 25 ° Celsius.

BASIC HAND CONTROL $980
HAND CONTROL WITH LED $1260
*plus GST and SHIPPING

Advantage of LED unit:

  • Clear reading of dialed settings
  • Built for rough working conditions
  • Low battery warning

SPECIAL PROMOTION

Refurbished demo units available for 25% off, with same 2-year warranty.

Basic hand controls only, while supply lasts.

The WAC Welding remote control is far ahead of other competitive products in functionality and ease of operation.

To use, plug the WAC remote cable into the welding unit Remote Control connector.  Power up, press the start button on the hand control and you are ready to weld. To vary the amperage – just turn the dial on the hand control. A beep and light will acknowledge your change immediately. When done welding, just press the RED button on the hand control to set the amperage to off.

Learn more about the WAC Welding unit

What sets the WAC Remote Control apart from the competition?

  • Operating range over 2000 feet vs. a few hundred feet
  • Acknowledgement from receiver unit on every amperage change
  • Half-power mode increases accuracy when welding with low amperage
  • Unlimited addressing ensures no interference with any other welders
  • Compact receiver unit with internal antenna
  • Powerful magnets hold hand control and receiver unit to any steel
  • Works on both Miller and Lincoln units
  • Using a dial rather than up/down buttons makes changing amperage much easier

CONNECT

POWER UP

SEND SIGNAL

WELD

ADJUST